I made a start last night fitting the disc brake kit. I hit a slight stumbing block in the terms of the brake pipe, my flexies are metric and the kit comes with a standard imperial end, so I think I shall have to re-use the old pipes. I imagine they’re the same at the brake caliper end. I found that the old pipes will work just fine:
I decided to bite the bullet today and crack on with the disc brake conversion. Having painted the new parts it was time to begin.
On the way back from Dorchester I thought I would check out the state of the two fords on Gascoyne Lane, the river level is up pretty high. I didn’t drive through either ford as I imagined they were plenty deep enough to drown my Land Rover.
Here are some pictures and a video of the bits I got from Zeus: Then I decided I should paint…
I put the floor and transmission tunnel back in, and then the front prop. And lastly the front prop:
I have been chasing this misfire vibration problem all around, having said I’d be ripping the gearbox out I started. I got the interior floor pan etc removed and front prop off. Then I took the rear prop off… Well, I checked both prop shafts when this issue first showed itself, I imagined this is what it would be, but they seemed fine, hence going down the paths I did. I noticed that there is a rubber seal which was, I guess, stopping the metal and metal action when I manually turned the prop and stopped it from clunking. So either way, new prop ordered and fitted tonight. I then dropped the floor back in and refitted the steering wheel, hand break mechanism and bits so that it’s drivable for a test. This may not be issue, but I hope it is.
We visiting Kingston Lacy on Saturday, it was most pleasant though the weather wasn’t great, but perhaps it was good enough. My phone battery went flat so I’d probably have taken more photos. There is a high window in the house, maybe 8 or 10 feet tall, the glass is original and over 100 years old. I had no idea that could make such large panes back then.
The gearbox extraction has commenced. I was thinking I’d remove the rear prop and go for a drive on the front axle only, but decided that pointless. Since if it were the diff surely it would cause issues at any time it was udner load, not just certain gears and rev ranges. So out comes the gearbox. I’ve got the lamp on the extension cord hanging by the dash for decent light.
I changed the oil on the Citreon C4 Grand Picasso on Saturday. Easy job. Next time it’ll be easier since the hole is now drilled in the under engine guard thingy. Although I’ll be disappointed not to find another snap on wrench.
Dorset Land Rover Club ran a Pay and Play at a site in Crossways. I got to go at member price because they have an agreement with Woolbridge. Then i and got stuck in a deep bit of water. I was pulled out and went off again having fun. Though i still have the issue and am not really any the wiser as to what it is. Though i think i blame the gearbox, so will be pulling that out next. Though i might remove the rear prop shaft first fo rule out the rear diff.
Recent Comments